JAX Chemical Brown Brass, Bronze & Copper Darkener produces an antique brown finish on brass, bronze and copper.
Using JAX Brown Darkener for Brass, Bronze and Copper is simple:
- 1.) Prepare and clean the surface to be treated
- 2.) Apply the JAX Brown
- 3.) Wash the JAX off the metal when the metal is slightly darker than your desired finish
- 4.) Relieve with Scotch-Brite
- 5.) Wash again with water and dry.
Wearing gloves is highly recommended as to not introduce oils from your hands to the metal. To be safe, eye protection is always recommended.
Use a bristle brush, sponge or rag and apply the JAX Brown directly to the metal. You may also dip the entire object into the solution. However, do not leave the metal in the solution, or the solution on the metal, for longer than necessary. If the metal is clean, the JAX Brown will work quickly. If left for too long the Brown will rub off the metal easily. Practice and experience will help you find the right timing for your work.
If you are going to dip your metal into JAX Brown, you may want to dilute the JAX with water; this will slow the reaction down and allow you to have more control over the finish (there is no magic dilution ratio – a little experimentation will allow you to arrive at the optimum ratio for your work).
If you are applying the JAX with a brush or sponge do NOT dilute the solution.
Once you have applied the JAX product to your satisfaction, rinse the metal well with fresh, clean water and dry.
At this point, you may use steel wool, a polishing cloth, or Scotch-Brite to achieve your desired finish. If you remove too much of the Brown finish, you may reapply the JAX Brown and start over.
If you seek to duplicate a particular finish, over-darken the metal and then “relieve” it with steel wool or a polishing cloth, as above. Once you are happy with your finish, you may wax, oil, or lacquer the metal as a final step, although in many cases leaving the metal “unprotected” may be desirable.
